Renovation of kitchens and bathrooms (baths, sinks, wash basins, etc.), household appliances, tiles and so on.
Atmosani restores youthful shine to the surfaces treated. With no need for dismantling or solvent, it is dry to the touch in 12 hours.
Long lasting resistance
Exceptional coverage a perfect lacquered finish without yellowing
Specially formulated for enamel and synthetic surfaces.
Completely dry within 72 hours. Shiny, smooth and knock-resistant. Kit contents: 1 tub of resin + 1 hardener, 2 pieces of sandpaper + 1 spatula, 1 pair
of plastic gloves, 1/2 l of acidic solution and 1 ATMOSANI roller, only available in white and covers up to 5 sq.m.
Solvent free.
Main uses:
Bath, basin, shower tray and bidet Wall tiles Domestic equipment other than surfaces near to a heat source such as a hob.
Method for use:
Preparing the surface:
The surface to be treated must be free from any dirt or limestone deposits.
To ensure that this is the case, first clean the surface using a green abrasive pad, without any detergent. Rinse well.
Using the sandpaper supplied with the kit, rub down the surface while moistening it in order to remove any traces of limestone deposits.
Again rinse well to remove any residues left after sanding down.
Dry the surface using a hair dryer.
Attention!
If a silicon seal has recently been applied, wait for the silicone to dry thoroughly, that
is, at least for 8 days before you apply Atmosani.
If there has been an impact to the original surface, fill it using ATMOS PASTE to obtain a smooth surface to be treated.
If the metallic surface of the object being renovated is exposed, neutralise it beforehand with a coat of ATMOS PASTE.
In any event, ensure that you respect the drying time for this product before using ATMOSANI.
IMPORTANT :
The product must be used in a single session by mixing all of the hardener into the contents of the pot of resin and mix together.
This product is an epoxy resin, which is very resistant once it has hardened.
The product must be used within approximately forty minutes.
Once this time has elapsed, the product begins to cure in the pot and progressively releases significant heat, which is perfectly normal.
Never leave the roller in the product.
Store your ATMOSANI kit at an ambient temperature of approximately 20°C for at least 24 hours prior to use.
Never store the product at a temperature lower than 15°C.
This kit is sufficient to renovate a surface area of up to 5 m².
This product is suitable for use on all suitably prepared non absorbent surfaces: enamel, earthenware, acrylic, sheet metal and enamelled cast iron, waxed concrete.