If the syringe is blocked, use a small pointed object to unblock it. This will not affect the effectiveness or quality of the product.
1 – Turn off the water supply.
2 – Sand, clean, degrease and dry the surface to be repaired.
3 – Break or cut off the rectangular end of the syringe.
4 – Remove the safety mechanism from between the 2 plungers. Keep this part safe as you will need it to reseal the syringe after use.
5- Press down on the plungers to release the desired amount of resin. An equal amount of both products should come out of the syringe.
Test the syringe before use to ensure that both products come out correctly.
Pull back on the plungers to stop the product coming out of the syringe.
6 – Use a spatula to mix the components until you obtain a solid, even color.
7 – You must apply the product within 5 minutes.
Close the syringe cap securely after use.
Dry to the touch in 30 minutes and fully cured in 12 hours.
Keep dry/do not use for at least 2 hours.
The resin can be sanded once completely hardened.
Not suitable for use on expanding surfaces.
ATMOSOLUTION TIPS :
The product is a liquid product. For a better finish, apply tape around the area to be treated.
The spatula and plastic shell are easier to clean once the resin has hardened.
When fresh (not hardened), it can be cleaned using a cleaning solvent.