Instructions for use :
For temporary repairs.
Turn off the water supply – if necessary.
1- Sand, clean, degrease and dry the surface to be repaired.
2- Remove the white protective paper.
3- Hold the end of the tape firmly against the surface and wrap around the area to be repaired, stretching the tape as much as possible (up to 6x).
First, wrap the tape around itself to make sure it stays securely in place.
4- Then apply in a spiral fashion with a minimum overlap of 50%, keeping the tape stretched.
Continue this until you have applied at least 3 layers and allow for a minimum of 5 cm on each side of the area to be repaired.
For leaks involving pressurized water (maximum 3 bars), apply 5 to 6 layers to obtain a “watertight” mass.
Pay particular attention to the ends and ensure maximum contact between the surfaces.
5- Tear or cut the tape.
If the tape breaks during application, or if you run out of tape, simply continue with another piece.
The second piece will fuse with the first one.
Wait at least 10 minutes for the product to stick properly.