For all materials
Can be used in wet environments
Sets in 15 minutes
The product should not be rolled up on itself, nor should it be used for angles or elbow joints.
It must be applied on a flat surface. Not suitable for diameters less than 80 mm.
For smaller diameters, use the ATMOSOLUTION PIPE REPAIR BANDAGE.
Instructions for use :
1 – Turn off the water supply and dry the surface as much as possible.
2 – Use the gloves provided when handling the product.
3 – Sand and clean the surface to be sealed before applying the patch.
4 – The wider side of the patch (8cm) should be positioned parallel to the surface.
5 – Open the aluminum pouch and remove the patch from its protective film.
6 – Apply the leak-proof patch to the surface to be repaired by stretching it along the edges and pressing down on the corners and sides.
7 – Lightly moisten the patch, e.g. with a spray bottle.
Sets in: 15 mins – Fully cured in: 12 hours.