Instructions for use :
If the syringe should become blocked, insert a sharp point or tip into the end to unblock it.
This will not impair the effectiveness or quality of the product.
1 – Turn off the water supply.
2 – Sand, clean, degrease the surface.
3 – Tear or cut the square end of the syringe cleanly.
4 – Remove the safety device between both plungers. Keep this piece since it will be used as a cap for the syringe after use.
5 – Press both plungers to release the desired amount of product. The amount must be identical for each component (the blister package will be used as a container.
Make a first test so both products come out). Pull the plungers back to stop the flow.
6 – Using the spatula, mix well the components until colour is uniform and homogeneous.
7 – You have 5 minutes to apply the product.
Close the syringe with the cap after use.
Dry to the touch within 30 min and complete curing within 12H.
Wait 2H at least before turning the water supply on.
Once completely cured, the product can be sanded.
Not suitable for expandable supports.
ATMOSOLUTION TIPS :
The product is relatively liquid, apply tape to delineate the area for a cleaner result.
The spatula and the blister package are easier to clean (mecanically only) only after product’s curing.
Fresh product can be cleaned with solvent.